Caravan signage
Do Not Overtake Turning Vehicle Reflective Sticker 300 × 100mm
What you are buying
Clearly communicate safe overtaking guidance with the Do Not Overtake Turning Vehicle Sticker
Designed for installation on the rear of caravans, trucks and other heavy vehicles, this reflective safety sticker features a high-visibility yellow background for clear identification by approaching motorists.
Features:
- Conforms to Australian Standard AS 4001-1
- High-visibility reflective yellow finish
- Durable adhesive backing
- Suitable for caravans, trucks and other heavy vehicles
- Clear black safety lettering
- Dimensions: 300mm wide × 100mm high
A practical safety addition for vehicles and combinations that require additional room when turning.
In the box
One sign, an alcohol prep wipe, and a one-page fitting card.
Where it goes
Rear of the caravan, as close to horizontal and as visible as the panel allows.
Fitting it
-
1
Pick the spot Affix the sign to the left-hand side on the rear of your caravan. Place it between 400mm and 2,000mm off the ground (around 1,500mm is ideal). Keep the left edge of the sign no further than 500mm from the extreme left side of the caravan.
-
2
Clean it properly Use wax and grease remover on the area you wish to fit.
-
3
Dry fit first Tape the top edge, stand back ten metres, check it reads level against the van, not against the ground.
-
4
Peel and press Peel the backing from the top, work down with firm pressure from the centre out. Leave it 24 hours before the first wash.
Specification
| Panel size | 300 × 1000 mm |
|---|---|
| Face film | Class 1 retroreflective, over-laminated |
| Colours | Black on standard sign yellow |
| Backing | Permanent acrylic adhesive, pre-applied |
| Weight | 0.6 kg |
Common questions
Do I legally need this sign?
For caravans it is not a legal requirement. It does however allow you to legally straddle 2 lanes when turning if the need arises. Failure to display this sign while doing so leaves you open to to possible fines and insurance implications should an accident occur.
Will it stick to a fibreglass or aluminium van?
Yes. The adhesive is a permanent acrylic rated for both. Clean the panel with wax and grease remover, allow to dry for 5 minutes, fit it above 10 degrees, and leave it 24 hours before washing.
Can I remove it later?
It comes off with heat and slow pull. Expect some adhesive residue that a citrus remover will lift. It is not designed to be moved between vans.
Is the print reflective at night?
The yellow ground is Class 1 retroreflective film, so it returns headlight at the same angles a road sign does. The black lettering is printed, not reflective, which is what gives the contrast.
How long does delivery take?
2 to 4 business days to most of Queensland and New South Wales, 3 to 7 elsewhere. Tracking is emailed when it leaves us.